Honeywell Thermostat T410 User Manual - Honeywell Thermostat Manual Download

Latest

Sunday, April 5, 2020

Honeywell Thermostat T410 User Manual

T410A,B Line Voltage Electric Heat Thermostats INSTALLATION INSTRUCTIONS T410A provides single-line break. T410B provides double-line break. 1 PREPARATION Temperature Range: 40 F to 80 F (4 C to 27 C) ° ° ° ° Proper installation of your Honeywell thermostat will Electrical Ratings: 60 Hz noninductive occur if you follow these instructions STEP-BY- 22A at 120-240 Vac; 19A at 277 Vac STEP. It is recommended that as you read, understand and complete each step, you check ✓ it off with pencil or pen. Do-It-Yourself models Check thermostat suitability for your home’s system Your Honeywell Thermostat by reviewing the ratings listed above. Your new Honeywell T410 Electric Heating Thermostat Make certain that your heating system is working, provides line voltage control of a radiant cable, electric especially if it has been inoperative for a length of baseboard, and resistive-rated fan forced heaters within time. If the system does not work, contact your local the ratings listed above. electrician for assistance. WARNING Carefully unpack your new thermostat. To avoid damage to the sensing element, do NOT remove This thermostat is a line voltage control (120 Volts to the thermostat cover until wiring has been completed. 240 Volts.) Do not install it if you are not completely familiar with house wiring. If handled improperly, there can be risk of a 120 Volt to 240 Volt electric Save packages of screws, instructions, receipt and shock hazard, which may cause serious injury or proof-of-purchase. death. MERCURY NOTICE 2 REMOVE OLD THERMOSTAT If this control is replacing a control that contains mercury in a sealed tube, do not place you old WARNING control in the trash. Dispose of properly. Begin by turning off power to the heating circuit at the main service panel. Contact you local waste management authority for instruction regarding recycling and the proper Remove cover of old thermostat—cover normally disposal of a old control. snaps off when pulled firmly from the bottom. If it resists, check for a screw that locks the cover. Loosen screws holding thermostat base to outlet box and lift away. Disconnect wires from old thermostat. As you disconnect each wire, tape the end and label it with the letter of the terminal designation to make reconnection to new thermostat easier. Check the old insulation for cracks, nicks or fraying, and apply high quality plastic tape where necessary for adequate insulation. Retain the old thermostat for reference purposes and until your new thermostat is functioning smoothly. ¨U.S. Registered Trademark Copyright © 2002 Honeywell ¥ ¥ All Rights Reserved X-XX UL 69-1562-1 T410A,B LINE VOLTAGE ELECTRIC HEAT THERMOSTATS 3 WIRE AND MOUNT NEW THERMOSTAT 4 CHECK OUT THERMOSTAT Remove thermostat cover by grasping the top and Turn on the power to the heating system. bottom ends with fingers, and pulling outward. Turn setting knob all the way clockwise ; listen Connect wires to the thermostat as shown in the for clicking sound as switch makes contact. Electric applicable wiring diagram. Push the wires into the heater should begin operation. outlet box, and insert the thermostat into the box for mounting by pushing against top and bottom of the Turn knob all the way counterclockwise ; listen thermostat base. for clicking sound as switch breaks contact. Electric heater should shut off. IMPORTANT: Do not press on setting knob. Secure the thermostat to the box with the two captive SETTING THERMOSTAT mounting screws provided. 5 Begin with setting knob at 70°F (20°C) on the scale. Replace thermostat cover. If this setting is not satisfactory after at least two Set knob to desired room temperature. hours of operation, turn setting knob upscale to raise the temperature, or downscale to lower the tempera- IMPORTANT: Rough handling or strong pressure can ture. Move knob only a degree each time. damage knob or sensing element, and change calibration. L1 (HOT) L2 1 T410B T410A 1 3 L2 L1 L1 2 4 4 T2 T1 T1 3 TO ELECTRIC HEATER ELECTRIC HEATER 1 POWER SUPPLY. PROVIDE DISCONNECT MEANS AND OVERLOAD PROTECTION AS REQUIRED. 2 BREAKS ON POSITIVE OFF. 3 EXPOSED UNUSED LEADWIRES TO BE PROPERLY INSULATED. 4 THERMALLY ACTIVATED—BREAKS ON TEMPERATURE RISE. MAKES ON TEMPERATURE FALL. CAUTION: SPECIAL SERVICE CO/ALR SOLDERLESS CONNECTORS MUST BE USED WHEN CONNECTING WITH ALUMINUM CONDUCTORS; OTHERWISE, A FIRE HAZARD CAN RESULT. M19099 69-1562Ð1 2 T410A,B LINE VOLTAGE ELECTRIC HEAT THERMOSTATS 6 TROUBLESHOOTING Your Honeywell thermostat requires little or no attention. Most problems can generally be traced to the following: Symptom Checkout Action No heat. Make sure power is on at Heater should start to warm up within two minutes. If not, main service panel. Turn contact qualified electrician to check thermostat and heater. the temperature setting knob fully clockwise . Improper connections to With power to circuit OFF, tighten all wiring connections. thermostat. Repair any frayed or broken wires. Other. Contact a qualified electrician for assistance. Heater never turns Turn temperature setting Heater should start to cool within minutes. If not, turn off off. knob fully power at the main service panel, and contact qualified counterclockwise . electrician. Thermostat setting Thermostat affected by Contact electrician to change the location. The thermostat and thermometer drafts or radiant heat. should be about 5 ft (1.5m) above the floor and on an reading disagree. inside wall. 3 69-1562Ð1 Limited One-Year Warranty Honeywell warrants this product to be free from defects in the workmanship or materials, under normal use and service, for a period of one (1) year from the date of purchase by the consumer. If, at any time during the warranty period, the product is defective or malfunctions, Honeywell shall repair or replace it (at Honeywell’s option) within a reasonable period of time. If the product is defective, (i) return it, with a bill of sale or other dated proof of purchase, to the hardware or home center store where you purchased it, or (ii) package it carefully, along with proof of purchase (including date of purchase) and a short description of the malfunc- tion, and mail it, postage prepaid, to the following address: Honeywell Return Goods in Canada: Honeywell Limited/Honeywell Limitee Dock 4 MN10-3860 35 Dynamic Dr 1985 Douglas Dr N Scarborough, Ontario M1V 4Z9 Golden Valley, MN 55422 This warranty does not cover removal or reinstallation costs. This warranty shall not apply if it is shown by Honeywell that the defect of malfunction was caused by damage which occurred while the product was in the possession of a consumer. Honeywell’s sole responsibility shall be to repair or replace the product within the terms stated above. HONEYWELL SHALL NOT BE LIABLE FOR ANY LOSS OR DAMAGE OF ANY KIND, INCLUDING ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING, DIRECTLY OR INDIRECTLY, FROM ANY BREACH OF ANY WARRANTY, EXPRESS OR IM- PLIED, OR ANY OTHER FAILURE OF THIS PRODUCT. Some states do not allow the exclusion of incidental or consequen- tial damages, so this limitation may not apply to you. THIS WARRANTY IS THE ONLY EXPRESS WARRANTY HONEYWELL MAKES ON THIS PRODUCT. THE DURATION OF ANY IMPLIED WARRANTIES, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PAR- TICULAR PURPOSE, IS HEREBY LIMITED TO THE ONE YEAR DURATION OF THIS WARRANTY. Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to your. This warranty gives you specific legal rights, and you may have other rights which vary from state to state. If you have any questions concerning this warranty, please write to Honeywell Customer Relations, 1985 Douglas Dr N, MN10-1461, Golden Valley, MN 55422. In Canada write Retail Products ON15-02H, Honeywell Limited/Honeywell Limitee, 35 Dynamic Dr, Scarborough, Ontario M1V 4Z9. Automation and Control Solutions Honeywell International Inc. Honeywell Limited—Honeywell Limitée 1985 Douglas Drive North 35 Dynamic Drive Golden Valley, MN 55422 Scarborough, Ontario M1V 4Z9 69-1562Ð1 G.H. 2-02 www.honeywell.com/yourhome

No comments:

Post a Comment

Popular Posts